User manual

Extended Settings and Functions
43
 Select Recalculation and press OK to discard any previous settings and to again de-
termine antenna position.
 Press EXIT to return to the submenu Antenna Setup.
 Select Limit setup and press OK to
open the window Limit setup.
1. Select Limit setup to switch between Disable Limit , West Limit and East Limit .
2. Mark the button Limit setup and move the limit - as defined in the previous step - to the
east or west by using the keys and .
3. Mark the button Go to Reference and then press OK to move the motor antenna to its
starting position.
4. Press EXIT to return to the submenu Antenna Setup.
9.1.3.2.2 USALS
A satellite position is defined as reference, and the data provided for latitude and longitude
are then used together with such basic values to calculate the rotary movement for all re-
maining satellites.
 Select Local Longitude to enter the longitude of the position of your antenna by using
the numeric keys of your remote control.
 Select Local Latitude to enter the latitude of the position of your antenna by using the
numeric keys of your remote control.
 Select Motor Setting and press OK to
open the submenu Motor Setting.
1. Select Satellite to select the satellite
that should be used as reference for
USALS control of the antenna.
2. Select Transponder to select the transponder that should be decisive for the antenna
position (usually the transponder that is used to send your preferred channel).
3. Align your motor antenna so that signal strength and signal quality (are displayed at the
lower screen edge) reach maximum values.
4. Press EXIT to return to the submenu Antenna Setup.
 In the submenu Antenna Setup, select the item Limit Setup and press OK to open the
window Limit Setup. Proceed as described above.
9.1.4 Single Satellite
Here you can scan individual satellites for receivable channels.
 At Satellite, select the satellite for which the scan should be performed.