User`s guide

NV5100MC Master Control • MasterDiag User’s Guide 21
3. Operation
Setup and Diagnos tic Pag es
reports “Software update was successful.” After a successful update, Ma sterDiag will also
prompt you to reset the MCPM.
You can force MasterDiag to re-read the setup data by clicking the ‘Read’ button.
Ethernet Settings
The ‘Ethernet Settings’ page allows you to change the IP address (and subnet ma sk) of the current
MCPM:
Figure 3-2. Ethernet Settings Page (Sample)
In most cases, if not all, the subnet mask should be 255.255.255.0.