Instruction manual

GUIDE TO INSTALLATION AND OPERATION
14 | RCP-200
4. In the SELECT area, turn the left-most control knob to choose IP ADDRESS
5. Use the four control knobs in the CHANGE area to enter a new address.
• The starting address is displayed in the CURRENT data box for reference
• The new address you are entering is displayed in the MODIFIED databox, as well as at the controls
6. When done, push the SAVE control knob to store the value
• Note that if you select another IP element, e.g. GATEWAY, before saving, your changes will be discarded.
7. Repeat the process for NETWORK MASK and GATEWAY
8. Restart the RCP-200 by pushing the control knob below RESTART to apply the changes
• The panel will go dark for about 15 seconds before the startup screens appear
Specify Appservers for the RCP-200
The RCP-200 needs to connect to an appserver in order to control devices. The IP addresses of these appservers can
be entered manually.
• If the list of appservers is empty at startup, the RCP-200 will do multicast discovery until the next reboot.
When you have decided which appservers you will access, proceed as follows:
1. Press the CONFIG button, located between the two screens on the front of the RCP-200.
2. Touch the COMM category on the right-hand screen
3. Touch the DISCOVERY tab on the right-hand screen