Instruction manual

GUIDE TO INSTALLATION AND OPERATION
RCP-200 | 17
4.4 Access Control
For operational situations where it is advantageous to limit access to some devices, RCP-200 allows access restrictions
to be established and controlled using a password login.
Access Control on the RCP-200 is an aspect of the Access Control functionality of iControl. For a detailed
description, please see the chapter on Access Control in the iControl Version 4.11 (or later) User Guide
(Miranda document M226-9900-274)
To use the RCP-200’s Access Control feature, an iControl administrator must set up the appropriate users, roles, and
permissions in iControl. Individual users of the RCP-200 may then be given their usernames and passwords. The
administrator is required to log in to the RCP-200 to turn access control ON or OFF.
The ADMINISTRATOR must:
• Set up the access control functionality in iControl, as described in the iControl manual.
• Turn ON or OFF the access control feature of the RCP-200.
The USER must:
• Log in to the RCP-200 to enable control of the cards that he is
authorized to use.
4.4.1 Turning Access Control ON
Once the access control functionality has been set up in iControl, the
administrator must turn it ON for the RCP-200. Proceed as follows:
1. Press Config on the front panel (between the two screens) and
touch CONTROL – SECURITY to display the access control
screen.
The current access control status (OFF) is displayed at the top
left corner of the screen.
2. Turn the control knob beneath the ENABLED area to display
ON.
3. The ACCESS CONTROL HOST dialog will appear, and the left hand screen will display a keyboard that will be
used for data entry in the following steps.