Instruction manual

GUIDE TO INSTALLATION AND OPERATION
RCP-200 | 21
Navigation Soft Keys
The right-most two soft keys are used for navigating through the list. They will only be labeled and enabled when they
are available for use. That is, if you are at the top of the list, you will not see an UP label on a soft key, and if you have
moved to the left-most column, you will only see a RIGHT key label. The button beneath the label will be dim, meaning
that it is available to be pushed.
• The right-most key is used to move DOWN and RIGHT
• The second key from the right is used to move UP and LEFT
UP / DOWN
The soft keys for up and down movement are labeled in black, and the button illumination will be dim.
• Push the key to move in the indicated direction.
LEFT / RIGHT
The soft keys for left and right movement are labeled in blue. This indicates that you must use the ALT key to access
them.
• Hold down the ALT key, which turns bright, and the available left and/or right soft keys will illuminate dim blue.
• While holding the ALT key, use the LEFT and RIGHT soft keys to navigate across the columns. Each key push
moves the display one column in the selected direction.
Sorting the List
The list can be sorted alpha-numerically based on the contents of any column.
• Touch the header of the column to sort the list based on that column
• The header will display an arrow icon indicating the sort direction
• Touch the header to change the sort direction
Note that the list is always sorted. By default, the initial sort after booting is by the left-most column (always LABEL),
increasing.
Filtering the List
Filtering is provided to narrow the focus of the list to make it easier to find a specific device.
SET FILTER – this soft key allows the user to set up filters that selectively restrict the number of devices displayed in
the list.
To set up a filter:
1. Navigate until a parameter of interest is shown on the screen
2. Press the SET FILTER button. It will flash between bright and dark.
• To cancel, press SET FILTER again
3. While the SET FILTER button is flashing, touch the parameter of interest
4. The displayed list will now show only devices that match the selected parameter.
5. The header of the column in which the parameter was selected will display an F
6. The DEL FILTER soft key will be labeled and available