Instruction manual

GUIDE TO INSTALLATION AND OPERATION
40 | RCP-200
The User Defaults Configuration window opens
Under “Supported Parameters” is an expandable tree listing
all the parameters on this device that can have user defaults
applied.
• Click on the box beside a closed folder to open the
folder and see its contents
• Click on the box beside an open folder to close the
folder and hide its contents
Beside each parameter are four items, beneath descriptive
headings.
Enabled: click on the checkbox to enable the user defaults
for this parameter
Default Value: click in the column beside the parameter of interest.
A scroll box opens showing the current value. Use the up and down arrows to select the desired Default Value, then
click outside the scroll box to close it and insert the selected value as the new default value.
∆− Lower tolerance: click in the column beside the parameter of interest.
A scroll box opens showing the current value. Use the up and down arrows to select the desired lower tolerance
value, then click outside the scroll box to close it and insert the selected value as the new lower tolerance value. Delta
values are absolute units relative to the default value.
∆+ Upper tolerance: click in the column beside the parameter of interest.
A scroll box opens showing the current value. Use the up and down arrows to select the desired upper tolerance
value, then click outside the scroll box to close it and insert the selected value as the new upper tolerance value.
Delta values are absolute units relative to the default value.
The figure shows the significance of these
values and how they are represented in the
slider display
Open the appropriate folders to locate a parameter whose default value and tolerances are to be set.
Default value
∆+
∆−
Actual value