User's Manual

MiraScreen
MiraScreen
MiraScreen
User manual
Ver. A 1.0
Wireless HD Transmitter
& Receiver Kit
Thank you for purchasing the MiraScreen products, For optimum
operation, please read this manual carefully before use.
Preface
Size:100*57mm
Connect the HD port or VGA port of the receiver to the video input port of
the display device such as the monitor or TV.
Connect the USB-C power supply port of the receiver to the charging cable
and plug it into the power adapter ( Voltage above 5V, current above 2A).
Adjust the HD Signal source of the monitor or TV to the corresponding HD
port untithe boot screen is displayed.
Connect the transmitter to the computer or other devices With HD video
output function . After the indicator Light enters the fast flash state , Wait for
ten seconds to complete Casting.
*Please make sure that the power of the computer is sufficient. If the
power supply of the computer is insufficient or HD is unable to supply
power , please connect the transmitter to the power adapter or USB-C
power supply port ( Voltage above 5V , current above 2A )
Turn on the Receiver power switch.
Function
Button
Indicator
Light
USB-C Power
Supply Port
HD
Receiver-RX
Transmitter-TX
USB-C Power
Supply Port
Indicator
Light
Function
Button
HD
ON-OFF
Switch
3.5mm
Jack
VGA
Please Press the receiver function button for more than 3 seconds, and the
prompt will pop up on the interface : Release the button to pair With Ezcast TX.
Wait for the transmitter to enter pairing mode
Press the transmitter function button for more than 3 seconds , the indicator
will flash for pairing , and Wait for the transmitter indicator to be always on,
indicating that the connection is successful.
Transmitter[TX] - Function Button
Receiver[RX] - Function Button