Technical Specifications

ICC-ES Evaluation Report ESR-3043
Reissued August 2017
This report is subject to renewal August 2018.
www.icc-es.org | [phone] | [phone] A Subsidiary of the International Code Council
®
DIVISION: 06 00 00—WOOD, PLASTICS AND
COMPOSITES
Section: 06 05 73.13—Preservative Wood Treatment
DIVISION: 07 00 00—THERMAL AND MOISTURE
PROTECTION
Section: 07 46 23—Wood Siding
REPORT HOLDER:
JELD-WEN, INC.
3737 LAKEPORT BOULEVARD
KLAMATH FALLS, OREGON 97601
[phone]
[e-mail]
www.miratectrim.com
EVALUATION SUBJECT:
MiraTEC
®
TREATED EXTERIOR COMPOSITE TRIM
1.0 EVALUATION SCOPE
1.1 Compliance with the following codes:
 2015, 2012 and 2009 International Building Code
®
(IBC)
 2015, 2012 and 2009 International Residential Code
®
(IRC)
 2013 Abu Dhabi International Building Code (ADIBC)
†
†
The ADIBC is based on the 2009 IBC. 2009 IBC code sections referenced
in this report are the same sections in the ADIBC.
 Other Codes (see Section 8.0)
Properties evaluated:
 Weather resistance
 Termite resistance
 Decay resistance above ground
 Corrosion
 Structural
1.2 Evaluation to the following green code(s) and/or
standards:
 2016 California Green Building Standards Code
(CALGreen), Title 24, Part 11
 2015, 2012 and 2008 ICC 700 National Green Building
Standard™ (ICC 700-2015, ICC 700-2012 and ICC 700-
2008)
.
Attributes verified:
 See Section 3.1
2.0 USES
MiraTEC
®
Treated Exterior Composite Trim is used as
nonload-bearing exterior trim.
3.0 DESCRIPTION
3.1 General:
MiraTEC
®
Treated Exterior Composite Trim is a wood
composite containing zinc borate at a minimum level of
0.75% (w/w). MiraTEC
®
Treated Exterior Composite Trim
is recognized for use in aboveground applications (UC3A)
and resists attack by fungal decay and subterranean
termites, including Formosan termites.
The attributes of the composite trim have been verified
as conforming to the requirements of (i) CALGreen Section
A4.405.1.1 for prefinished building materials and Section
A5.406.1.2 for reduced maintenance; (ii) ICC 700-2015
and ICC 700-2012 Sections 602.1.6 and 11.602.1.6 for
termite-resistant materials and Sections 601.7, 11.601.7,
and 12.1(A).601.7 for site-applied finishing materials; and
(iii) ICC 700-2008 Section 602.8 for termite-resistant
materials and Section 601.7 for site-applied finishing
materials. Note that decisions on compliance for those
areas rest with the user of this report. The user is advised
of the project-specific provisions that may be contingent
upon meeting specific conditions, and the verification of
those conditions is outside the scope of this report. These
codes or standards often provide supplemental information
as guidance.
3.2 Material:
The material is formed by blending a zinc borate slurry with
hardwood fibers and then laying down a continuous mat.
The mat is hot pressed to form boards which are then cut
to size and primed.
MiraTEC
®
Treated Exterior Composite Trim is available
in widths of nominal 2-inch trim [actual size 2 inches
(51 mm)], nominal 3-inch trim [actual size 2.75 inches
(70 mm)], nominal 4-inch trim [actual size 3.5 inches
(89 mm)], nominal 5-inch trim [actual size 4.5 inches
(114 mm)], nominal 6-inch trim [actual size 5.5 inches
(140 mm)], nominal 8-inch trim [actual size 7.25 inches
(184 mm)], nominal 10-inch trim [actual size 9.25 inches
(235 mm)], nominal 12-inch trim [actual size 11.25 inches
(286 mm)], and nominal 16-inch trim [actual size
15.5 inches (394 mm)] and in thicknesses of
5
/
8
inch
[actual thickness 0.625 inch (16 mm)], 4/4 [actual thickness
0.75 inches (19 mm)], 5/4 [actual thickness 1.0 inch
(25 mm)], and 1
1
/
4
inch [actual thickness 1.25 inches
(32 mm)].
ICC-ES Evaluation Reports are not to be construed as representing aesthetics or any other attributes not specifically addressed, nor are they to be construed
as an endorsement of the subject of the report or a recommendation for its use. There is no warranty by ICC Evaluation Service, LLC, express or implied, as
to any finding or other matter in this report, or as to any product covered by the report.
Copyright © 2017 ICC Evaluation Service, LLC. All rights reserved. Page 1 of 3