Installation Instructions

ManualsBrandsMiravac ManualsDomestic AppliancesRobotic Vacuum Cleaner

6. Rinse the dust bin with tap water. It is not necessary to wash every time.

Please do not put it into the washing machine to do the cleaning.

7. Periodically clean the filter with a soft bristle brush.

8. Once dry, reinstall the filter and the dust bin lid.

9. Place back the dust bin and the Top Cover

ATTENTION!! Before starting the cleaner, please be sure the dust bin filter has

properly installed in case any damage occurs.

CLEANING AND MAINTENANCE

Side buckle

Summary of content (7 pages)

PAGE 1
CLEANING AND MAINTENANCE 6. Rinse the dust bin with tap water. It is not necessary to wash every time. Please do not put it into the washing machine to do the cleaning. 7. Periodically clean the filter with a soft bristle brush. 8. Once dry, reinstall the filter and the dust bin lid. Side buckle 9. Place back the dust bin and the Top Cover ATTENTION!! Before starting the cleaner, please be sure the dust bin filter has properly installed in case any damage occurs.
PAGE 2
CLEANING AND MAINTENANCE Cleaning Intake: After repeated use, dirt and dust can accumulate around the intake of the M680GMA and the working efficiency can be reduced. To ensure the best efficiency and constant airflow, the intake should be cleaned periodically. Intake Valve Cleaning Side Brushes: 1. After being used for a period of time, the brushes need to be replaced for working more effectively. 2. Turn off the power, place bottom of the cleaner upward on a flat surface.
PAGE 3
CLEANING AND MAINTENANCE Cleaning TPE Roll Brush: After repeated use, dirt and dust can accumulate around the intake and TPE Roll Brush of the M680GMA and the working efficiency can be reduced. To ensure the best efficiency and constant airflow, the intake should be cleaned periodically. 1. After being used for a period of time, the TPE Roll Brush need to be replaced for working more effectively. 2. Turn off the power, place bottom of the cleaner upward on a flat surface.
PAGE 4
CLEANING AND MAINTENANCE Maintenance of Main Wheels: Follow below Instruction if Cable is twined or strangled or Clean needed.
PAGE 5
TROUBLE SHOOTING Problem Possible Cause Solution 1 Turn on the power switch with no LED display shown. 1. Battery is not installed correctly. 2. Very low battery. 1. Install the battery according to the manual. 2. Charge the battery according to the manual. 2 Vacuum on but can not collect dirt or hair. 1. The dustbin is full. 2. The filter is not installed correctly. 1. Clean the dustbin. 2. Re-install the filter correctly. 3 The side brush becomes crooked, not good to sweep.
PAGE 6
WARNING OF BATTERY & ADAPTOR USAGE 1. The protective devices cannot be reset or replaced after a short circuit or an overload. 2. Please follow the voltage and current specified and printed on the packing labels. Check with salesman or local power company if it is uncertain. 3. To avoid the hazard from battery short circuit, please follow the instruction of installing battery exactly. 4. The adaptor is applied indoors only. 5.
PAGE 7
WARNING OF BATTERY & ADAPTOR USAGE 14. Do not try to disassemble the battery. 15. Do not disregard kids playing with battery. 16. Do not contact eyes, skin, clothes with battery leaking fluid, wipe the leaking battery with dry cloth before recycle it properly.