User's Manual

13 (25)
4.0 Field Wiring
4.1 To Wire the Terminals
Figure 2 on page 10 shows the location of the terminals.
4.1.1 Required Tools
• Micro screwdriver, bladed, size: 0.4 x 2.0 x 60 mm
• Wire cutter
• Wire stripper
To wire the terminals
• Insert the wire into the bottom round hole on the right side (the side with the labels).
To remove the wire
• Insert a micro screwdriver into the top hole to release the wire.
Caution: Installation of OpenBAS controllers must be in accordance with the Canadian
Electrical Code or the National Electrical Code, and comply with all local
regulations. Appropriate wiring and conduit should be used in compliance
with local regulations. Final acceptance is subject to the Local Authority
Having Jurisdiction (AHJ).
!