Specifications

24
Cable and Jumper Connections for Main Board, Core Board and Adder Modules
6.0 Cable and Jumper Connections for
Main Board, Core Board and Adder
Modules
6.1 Main Pre-Action/Deluge and Agent Release Control Board
Figure 6 Main Control Board cable connector and jumper settings
S - + N C N O C N C N O C N C N O C N C N O C
JW 2
JW 1
- + - + - + - + - + - +
D E T 1 D E T 2 D E T 3 D E T 4 D E T 5 D E T 6
- + - + - + - + - + - +
SIG 1 SIG 2 SIG 3 SIG 4
AUX
4-WIRE SPLY
COM- COM+ TRB TRL
UNFLTD SPLY RTI PORT
JW 5
JW 6
JW 4
T O P R - 3 0 0 M O D U L E
TO R M - 3 0 6 R E L A Y M O D U L E
R S - 4 8 5 A U X . R E L A Y A L A R M R E L A Y
S U P E R V I S O R Y
R E L A Y
T R O U B L E
R E L A Y
RS - 485 for
annunciators
Auxiliary Relay
Alarm Relay
Supervisory
Relay
Trouble Relay
Unfiltered 24 V
supply
Connect to
RM 306 Relay
module
Connect to PR - 300
JW 2 - ON - when
RM-306 not connected
JW 1 - ON - when
PR - 300 not connected
POWER
SIGNAL
JW6-Normally Open
JW 4 - Normally Short
JW 7
For front panel programming use CFG-300
configuration tool not UL-864 or ULC-S527
listed. Please refer to Document LT-922 for
details
Initiating zones 1 to 6
5 JW - Normally Open
Power supply and
control interface, including
AC power and battery supplies.
Indicating/Releasing zones 1 to 4
P3 P4
SYSTEM
RESET
AC ON
X
M
?
GROUND FAULT
CPU FAIL
ABORT
RELEASE
COMMON ALARM
COMMON SUPV
REMOTE TROUBLE
COMMON TROUBLE
BATTERY TROUBLE
SIGNAL
SILENCE
AUXILIARY
DISCONNECT
LAMP
TEST
BUZZER
SILENCE
RAC2
(ZONE 4)
RAC1
(ZONE 3)
NAC2
(ZONE 2)
NAC1
(ZONE 1)
IAC6
(ZONE 1)
IAC5
(ZONE 5)
IAC4
(ZONE 4)
IAC3
(ZONE 3)
IAC2
(ZONE 2)
IAC1
(ZONE 1)
PRE
RELEASE
JW5
JW4
JW4 -Factory Use Only
Always Short
JW5- Factory Use Only
Always Open
Main Board
Core Board