Specifications

48
Configuration
10.0 Configuration
Configure the FR-320 Series Panels using the CFG-300 LCD Tool (see further documentation
packaged with CFG-300 for configuration information).
10.1 Using the CFG-300 Tool
Connect the CFG-300 to the panel, then press (Menu button). The CFG-300 LCD display
will display the Main Menu. The function of different buttons on the front panel display is
shown in Figure 22 below.
Figure 25 FR-320 Configuration
10.2 Entering the Passcode
The programming section is passcode protected. The following screen shows the message
that is displayed to enter the passcode. The maximum allowable passcode is ten digits long,
and permits numerical values only. Press (Enter button) after entering the passcode. If
the passcode is correct, it will take you to the main command menu. If the passcode is wrong
M
SYSTEM
RESET
AC ON
X
M
?
GROUND FAULT
CPU FAIL
ABORT
RELEASED
COMMON ALARM
COMMON SUPV
REMOTE TROUBLE
COMMON TROUBLE
BATTERY TROUBLE
SIGNAL
SILENCE
AUXILIARY
DISCONNECT
LAMP
TEST
BUZZER
SILENCE
PRE
RELEASE
RAC2
(ZONE 4)
RAC1
(ZONE 3)
NAC2
(ZONE 2)
NAC1
(ZONE 1)
IAC6
(ZONE 1)
IAC5
(ZONE 5)
IAC4
(ZONE 4)
IAC3
(ZONE 3)
IAC2
(ZONE 2)
IAC1
(ZONE 1)
0
QZ
8
TUV
7
PRS
9
WXY
1
2 
ABC
3
DEF
4 
GHI
5
JKL
6 
MNO
This label
removed from
this location
represents the
alternate
functions of the
corresponding
buttons in
service mode
*
(left shift)
#
(right shift)