Specifications

65
Configuration
Command Menu-->Dialer-Config
10.10.5 Dialer Enable/Disable
10.11 8. Test Dialer (Command-Menu)
Command Menu/Dialer-Config/Time
Parameter
3. Auto test time
00:30 ->Default
Use this function to set the time for auto test.
This test has to be performed once a day to
send the test report to the monitoring station.
The time is in 24hr format, which means
00:30 is 30 minutes after mid-night. Press
the UP or DOWN buttons to increase or
decrease the time.
Please do not use the following test
times: 00:00, 01:55, 02:00 and 03:00.
Note: Refer to 10.3 How to Use the Keypad to Program the FR-320 on page 49 for
detailed instructions on making menu selections.
[X] ENABLE ->Default
[ ] DISABLE
The dialer is enabled by default. When the
dialer is enabled or disabled, a warning
message appears.
Warning: The dialer cannot report any event
to the monitoring station if it is disabled.
Press Enter to test Line #1. Press Cancel to exit this menu. For
a description of test messages, see Dialer Test Messages on
the following page.
Press Enter to test Line #2. Press Cancel to exit this menu. For
a description of test messages, see Dialer Test Messages on
the following page.
Auto-Test (HH:MM):
00:30
i
Dialer Ena/Dis
[X] ENABLE
------WARNING-----
Dialer Disabled!!!
-Dialer Test-
1. L#1 Manual test
2. L#2 Manual test
3. Reset Dialer
L#1 Manual test
L#2 Manual test