Specifications

MIRCOM TECHNOLOGIES LIMITED, 9500 Series: No Subscriber Line Page 31
Please enter choice:
Press # to Store or * to abort entry. Repeat this process until all codes are entered. When finished, press * to
return to PROGRAM MODE menu. To quit, enter *000 while at PROGRAM MODE menu to return to NORMAL
MODE.
NOTE: IF ELEVATOR-RECALL (RESTRICTION) IS TO BE USED, PLEASE DESIGNATE FIRST TWO DIGITS
OF RESIDENT’S CODE AS THE RESIDENT’S FLOOR NUMBER. FOR EXAMPLE: A RESIDENT LIVES ON
THE SEVENTH FLOOR, THEIR RESIDENT CODE SHOULD BE 07XX WHERE XX IS A NUMERIC NUMBER
(01 TO 95) OF YOUR CHOICE. PLEASE REFER TO THE ELEVATOR-RECALL (RESTRICTION) SECTION IN
THIS MANUAL FOR FURTHER INFORMATION.
ENTRY, REVIEW, EDIT or DELETE DIAL CODES AND RESIDENTS'/TENANTS’ NAMES
To enter, review, edit or delete Dial Codes and Resident /Tenant Names, scroll through until you reach the feature
as shown below.
[1=Bck] [3=Fwd]
Do you want to edit
TENANT Names ?
[*=Abort] [#=Yes]
Press # to access the feature. The display should appear...
====TOP-OF-LIST=====
xxxx: <== Second line with “:” displayed can
xxxx be selected by pressing “0".
xxxx Where: xxxx are the Dial Codes.
Note: Press any number to exit.
Press * or # to scroll (review) "up or down" the list . To enter,edit, and delete the resident/tenant name, scroll until
the desired Access Code and Resident/Tenant Name is in the second line of the display.
Press "0" to enter, edit or delete Dial Code and Resident /Tenant Name. The next screen should appear....
-Program Options-
CODE:xxxx Relay:xxxx
NAME:xxxxxxxxxxxxxxx
Please enter choice:
1and 3 to scroll "up or down" the character set. Character Set table is given on Appendix E.
7and 9 to move the cursor "left or right".
# to delete the displayed Dial Code and Resident Name.
CAUTION!: Deleting a Dial Code and Resident Name will also delete the corresponding Relay #.
After entering resident/tenant name, press * . The next screen should appear...
-Program Options-
* = Abort, # = Store
Name:xxxxxxxxxxxxxxx
Please enter choice:
Press * to abort or # to store entry. Repeat the above process until all residents' names are entered. When
finished, press * to return to PROGRAM MODE menu. To quit, enter *000 while at PROGRAM MODE menu to
return to NORMAL MODE.