Specifications

MIRCOM TECHNOLOGIES LIMITED, 9500 Series: No Subscriber Line Page 32
AUTO PROGRAMMING RESIDENTS'/TENANTS’ DIAL CODES
This feature is provided to allow the user to program the Dial Codes automatically. In addition, the user can specify
the "quantity" (number of codes) and "access codes start number" for quick installation.
Scroll through until you reach the feature as shown below.
[1=Bck] [3=Fwd]
Do you want to AUTO-
PROGRAM Codes ?
[*=Abort] [#=Yes]
Press # to access the feature. The display should appear...
-Program Options-
Quantity: _ _ _ (<xxx) <----where: xxx is the maximum resident capacity
Codes start at: _ _ _ _ <----4 digits access codes
Please enter choice:
CAUTION!: Using Auto Program will replace all those previously programmed codes.
Enter the desired "quantity" (number of codes) and "start number" for Dial Codes. The system should
automatically program the codes incrementally by one (1). Please note that the Relay/Line Number will always
start at 0000. For example, the start number is 1500, the data stored in the memory should be as shown below.
Code Relay number
1500 0000
1501 0001
1502 0002
etc.
While the system is programming, the message will appear...
Now PROGRAMING!
- Please Wait-
When finished, the system should exit to the PROGRAM MODE menu. To quit, enter *000 to return to NORMAL
MODE.
PROGRAMMING KEYLESS ENTRY CODES
The system can provide up to 1000 Keyless Entry Codes for residents and 5 spares for building management. The
Keyless Entry Codes allow authorized residents/tenants to enter a code directly at the keypad to release the door
without the necessity of calling the resident. For obvious reasons, keyless entry codes should be kept well guarded
and controlled.
[Operation: press "0" followed by the four digit Keyless Entry Code]
To enter Keyless Entry Codes, scroll through until you reach the feature as shown below.
[1=Bck] [3=Fwd]
Do you want to enter
KEYLESS Codes ?
[*=Abort] [#=Yes]
Press # to access the feature. The display should appear...