Specifications

MIRCOM TECHNOLOGIES LIMITED, 9500 Series: No Subscriber Line Page 42
To Exit PROGRAM
MODE - Press #
At this menu, pressing * will lead you to the PROGRAM MODE menu. Pressing # will exit the PROGRAM MODE.
Press 3 again for next menu. The screen should lead you to the first feature menu.
NOTE: Repeat the above process to locate the desired feature.
To exit to Normal Mode, enter *000 while at PROGRAM MODE menu.
MANUAL ENTRY OF RESIDENTS'/TENANTS’ DIAL CODE AND RELAY #
Residents'/Tenants’ Dial Code can be entered in the format of 1, 2, 3, or 4 digit. These codes are used to call the
residents using the Entry Panel's keypad. Use the information given on APPENDICES "D-1 and D-2" to program
the residents' codes. To enter codes manually, scroll through until you reached the feature as shown below.
To Enter TENANT
Codes - Press #
Press # to access feature. The screen should display...
Code Relay #
_ _ _ _ _ _ _ _
Enter Dial Code and Relay/Line number. When you make a mistake and wish to reenter the code, press * to enter
code again. After entering the Code and Relay number, the next screen should display...
for one (1) digit dial code
Enter: 00xx for two (2) digits dial code
#=Store, *=Abort Enter: 0xxx for three (3) digits dial code
x x x x x x x x Enter: xxxx for four (4) digits dial code
To call a resident with two digits dial codes, simply enter xx
Where: 0 - Zero, x - Resident Dial Code (digit 0 to 9)
Press # to Store or * to abort entry. Repeat this process until all codes are entered. When finished, press * to
return to PROGRAM MODE menu. To quit, enter *000 while at PROGRAM MODE menu to return to NORMAL
MODE.
REVIEW AND DELETE RESIDENTS’/TENANTS’ DIAL CODES
To review and delete the residents'/tenants’ codes, scroll through until you reach the feature as shown below.
To Edit TENANT
Codes - Press #
Press # to access the feature. The display should appear...
Code to Review
_ _ _ _
Enter the code to review. The next display should appear...
Code Relay #
x x x x x x x x
Press 1 or 3 to scroll up or down the list. To delete the displayed code, press #.
CAUTION!: Deleting a Code will also delete the assigned Relay #.
When finished, press * to exit to PROGRAM MODE menu to select other features. To quit, press *000 while at
PROGRAM MODE menu to return to NORMAL MODE.