Specifications
Table Of Contents
- Page 1
 - Page 2
 - Page 3
 - Page 4
 - Page 5
 - Page 6
 - Page 7
 - Page 8
 - Page 9
 - Page 10
 - Page 11
 - Page 12
 - Page 13
 - Page 14
 - Page 15
 - Page 16
 - Page 17
 - Page 18
 - Page 19
 - Page 20
 - Page 21
 - Page 22
 - Page 23
 - Page 24
 - Page 25
 - Page 26
 - Page 27
 - Page 28
 - Page 29
 - Page 30
 - Page 31
 - Page 32
 - Page 33
 - Page 34
 - Page 35
 - Page 36
 - Page 37
 - Page 38
 - Page 39
 - Page 40
 - Page 41
 - Page 42
 - Page 43
 - Page 44
 - Page 45
 - Page 46
 - Page 47
 - Page 48
 - Page 49
 - Page 50
 - Page 51
 - Page 52
 - Page 53
 - Page 54
 - Page 55
 - Page 56
 - Page 57
 - Page 58
 - Page 59
 - Page 60
 - Page 61
 - Page 62
 - Page 63
 - Page 64
 - Page 65
 - Page 66
 - Page 67
 
MIRCOM TECHNOLOGIES LIMITED, 9500 Series: No Subscriber Line Page 62
• Automatic Alarm Initiating Devices 
Smoke detectors, heat detectors and other alarm initiating devices that are a part of this system may not
properly detect a fire condition or signal the control panel to alert occupants of a fire condition for a number of
reasons, such as: the smoke detectors or heat detector may have been improperly installed or positioned;
smoke or heat may not be able to reach the alarm initiating device, such as when the fire is in a chimney, walls
or roofs, or on the other side of closed doors; and, smoke and heat detectors may not detect smoke or heat
from fires on another level of the residence or building. 
• Software
Most Mircom products contain software. With respect to those products, Mircom does not warranty that the
operation of the software will be uninterrupted or error-free or that the software will meet any other standard of
performance, or that the functions or performance of the software will meet the user’s requirements. Mircom
shall not be liable for any delays, breakdowns, interruptions, loss, destruction, alteration or other problems in
the use of a product arising our of, or caused by, the software.
Every fire is different in the amount and rate at which smoke and heat are generated. Smoke detectors cannot
sense all types of fires equally well. Smoke detectors may not provide timely warning of fires caused by
carelessness or safety hazards such as smoking in bed, violent explosions, escaping gas, improper storage of
flammable materials, overloaded electrical circuits, children playing with matches or arson. 
Even if the smoke detector or heat detector operates as intended, there may be circumstances when there is
insufficient warning to allow all occupants to escape in time to avoid injury or death. 
• Alarm Notification Appliances 
Alarm Notification Appliances such as sirens, bells, horns, or strobes may not warn people or waken someone
sleeping if there is an intervening wall or door. If notification appliances are located on a different level of the
residence or premise, then it is less likely that the occupants will be alerted or awakened. Audible notification
appliances may be interfered with by other noise sources such as stereos, radios, televisions, air conditioners
or other appliances, or passing traffic. Audible notification appliances, however loud, may not be heard by a
hearing-impaired person. 
• Telephone Lines 
If telephone lines are used to transmit alarms, they may be out of service or busy for certain periods of time.
Also the telephone lines may be compromised by such things as criminal tampering, local construction, storms
or earthquakes. 
• Insufficient Time
There may be circumstances when the system will operate as intended, yet the occupants will not be protected
from the emergency due to their inability to respond to the warnings in a timely manner. If the system is
monitored, the response may not occur in time enough to protect the occupants or their belongings. 
• Component Failure 
Although every effort has been made to make this system as reliable as possible, the system may fail to
function as intended due to the failure of a component. 
• Inadequate Testing 
Most problems that would prevent an alarm system from operating as intended can be discovered by regular
testing and maintenance. The complete system should be tested as required by national standards and the
Local Authority Having Jurisdiction and immediately after a fire, storm, earthquake, accident, or any kind of
construction activity inside or outside the premises. The testing should include all sensing devices, keypads,
consoles, alarm indicating devices and any other operational devices that are part of the system. 
• Security and Insurance 
Regardless of its capabilities, an alarm system is not a substitute for property or life insurance. An alarm
system also is not a substitute for property owners, renters, or other occupants to act prudently to prevent or
minimize the harmful effects of an emergency situation. 
IMPORTANT NOTE: End-users of the system must take care to ensure that the system, batteries, telephone
lines, etc. are tested and examined on a regular basis to ensure the minimization of system failure. 










