Specifications

Module Settings
14
Figure 9 Main Display Module (MCC-1024-6, MCC-1024-12)
Connectors
P1: Cable connects to P3 of main fire alarm module.
P2: Connection to P1 of ECH-1048 display Module if used.
SW1 to SW5: See System Configuration on page 40 and Indicators, Controls, and Operation on page 32.
The main display module provides four dedicated display points for the four indicating circuits on the main fire alarm
module. It also provides the following general-purpose display points:
Note: The main display module comes with a Label Sheet (NP-2854) including both English and French
slide-in labels. This sheet may be run through a laser printer for labelling purposes before being
installed. The first slide-in section comes in two versions; one for single-stage systems, and one for
two-stage systems.
Chassis Type Display Points
MCC-1024-6 24
The main display has dedicated display points for the eight initiating circuits and four indicating
circuits that are located on the main board.
MCC-1024-12 24
P1
P2
1814 18 18 18
CONFIG.
SIG. ZONE
DISCONNECT
DET. ZONE
DISCONNECT
ZONE
DISCONNECT
ZONE
DISCONNECT
COMMON
1
ZONE
2
ZONE
3
ZONE
4
ZONE
5
ZONE
6
ZONE
7
ZONE
8
ALARM
SUPERVISORY
COMMON
BATTERY/
CHARGER
TROUBLE
REMOTE
FAILURE
TEST/CONFIG
MODE
SYSTEM
RESET
FIRE
DRILL
ACKNOW-
LEDGE
GENERAL
ALARM
COMMON
TROUBLE
A.C.
ON
LAMP
TEST
AUXILIARY
DISCONNECT
BUZZER
SILENCE
SIGNAL
SILENCE
CPU FAULT
GROUND FAULT
SIGNAL 1
TROUBLE
SIGNAL 2
TROUBLE
SIGNAL 3
TROUBLE
SIGNAL 4
TROUBLE
ZONE