Owner's Manual

STAND-ALONE DIGITAL ALARM COMMUNICATOR DTC-300A
Mircom reserves the right to make changes at any time without notice in prices, colours, materials, components, equipment, specifi cations and models and also to discontinue models.
5316
NOT TO BE USED FOR INSTALLATION PURPOSES.
S5434
7300-1477:151
Features
Connects to any 24VDC fi re alarm control panel •
to provide fi re reporting to a monitoring facility
Transmits information for six confi gurable input •
zones on two telephone lines to a Digital Alarm
Communicator Receiver (DACR)
Input zones can be confi gured for Common •
Alarm, Common Supervisory, Common Trouble,
Common Waterflow Alarm, AC Power Fail
Trouble and Battery Trouble
DTC-300A has the ability of disconnecting the •
incoming and outgoing calls and capturing
the line for transmission to the Digital Alarm
Communicator Receiver (DACR)
Onsite or remote programming•
Onsite confi gurable with the on-board keypad •
and the CFG-300 Confi guration Tool or using the
UIMA Programming Tool and caomputer with an
available serial or USB port
Remotely confi gurable via a Personal Computer •
with a modem (Configuration is passcode
protected)
Provides telephone line monitoring and reports •
status via LED indication on-board
Provides event logs of 500 entries each to save •
events from local dialer or remote fi re alarm
panel
Logs can be reviewed locally with the CFG-300 •
Confi guration Tool or remotely via modem
Continuously supervises the status of each of •
two connected telephone lines at approximately
one minute intervals
Provides LED indication for AC Power, Common •
Trouble, CPU Fail and Ground Fault
Requires 24VDC fi ltered or 24VDC Full Wave •
Rectifi ed (FWR) power supply
Description
The DTC-300A Stand-Alone Digital Alarm
Communicator Transmitter/Dialer Module is a six
zone fi re alarm communicator that can be connected
to any 24 VDC fi re alarm control panel to provide fi re
reporting to a monitoring facility.
The DTC-300A utilizes two telephone lines to
transmit information for six confi gurable input zones
to a Digital Alarm Communicator Receiver (DACR).
The input zones can be confi gured for Common
Alarm, Common Trouble, Common Supervisory,
Common Waterfl ow Alarm, AC Power Fail Trouble
and Battery Trouble.
The DTC-300A requires a 24VDC fi ltered or 24VDC
Full Wave Rectifi ed (FWR) power source. The Digital
Communicator can be programmed for dual line
operation and uses the Security Industry Association
(SIA) and Ademco Contact ID reporting protocols.
The DTC-300A can be confi gured locally via the on-
board keypad and the CFG-300 Confi guration Tool or
with a UIMA programming tool and a computer with
an available serial or USB port. In addition the DTC-
300A can be remotely confi gured using a personal
computer with a modem.
CATALOG NUMBER
firealarmresources.com