Installation manual

14
Installation
1.3.1 If you have a USB cable:
1. Connect the USB end of the serial to USB cable to a USB port on the computer.
2. Connect the other end of the USB cable to port P13 on the FX-3500. It is labeled USB
PORT.
Figure 9 Picture of FX-3500 board showing USB Port
3. Go to section 1.4 Starting the Windows Device Manager on page 16.
Attention: If you connect more than one FX-3500 panel to the same computer over
USB, always use the same physical USB port on the computer.
Otherwise, every time that you connect a panel to a different port, you
must complete the steps in section 1.5 below.
In addition, if you connect more than one FX-3500 panel to the same
computer, do not use a USB 3 port. Otherwise, every time that you
connect a new panel to the USB 3 port, you must complete the steps in
section 1.5 below.
!
P13
USB PORT