Installation manual

Installation

1.3.2 If you are using a UIMA cable and a serial cable

1. Connect the serial to serial cable to the UIMA cable.

2. Connect the 10-pin head of the UIMA cable to port P5 on the FX-3500. It is labeled To

PC Configurator. See Figure 10.

Figure 10 Picture of FX-3500 board showing Configurator Port

3. Connect the the other end of the serial cable to a serial port on the computer.

4. Go to section 1.4 Starting the Windows Device Manager below.

1.3.3 If you are using a telephone cable

1. Connect the telephone cable to the modem that is connected to your computer.

2. Wire the FX-3500 to the public telephone switch. See the Dialer Wiring section of the

FX-3500 Installation Manual and the FX-3500RCU Installation Manual.

3. Go to chapter 2.0 User Preferences on page 23.

To PC Configurator