Installation manual

35
Job Tree and Details Pane
As holidays are added or removed, the list on the "parent" form is maintained to be in
agreement. An error message is displayed if the limit for the total number of holidays would be
exceeded.
To remove a holiday
1. Select the desired date from the Holidays defined list and press Delete Selected
Holiday and the holiday will be removed.
2. Press Close to return to the Job Details form.
5.1.7 Port Settings
5.2 Base I/O
Used to set the starting address for AP Devices. If the address is set to 1 CLIP devices are not
permitted to be used.
Figure 28 Base I/O Details
5.3 Loops
The list view displays the hard wired (Conventional) circuits or addressable devices of a Loop,
when that loop is selected in the tree. The base set of columns is the same for both, but there
are some Product and Loop Type dependencies.
Port Protocol Printer, None
Port Baud Rate to be added
Note: When mixing modes every address assigned to CLIP removes the equal amount
of addresses from the Advanced Protocol addressable sensor and addressable
module range.
i