Installation manual

Job Tree and Details Pane

5.8 Dialer

This form is displayed when the Dialer tree item is selected. It allows you to configure the

UDACT / Dialer. The dialer can dial out on two phone lines. You must configure an account

and specify the line attributes for both. Line 2 can dial a cell phone. If this is the case the auto

test can be reduced from daily to monthly. The panel can also be configured from the

configuration tool by dialing in to the dialer. See Connect for full details.

5.8.1 Account 1

5.8.2 Account 2

5.8.3 Line 1

F2 Yes

For Bypass and Manual Switches, this flag can be set to AR (Aux

Reset Required). For Correlatable Switches it can contain NS (Non

silenceable)

F3 Yes

For Correlatable Switches this flag can contain GA (2nd stage, GA

device). For Bypass and Manual Push Switches it can contain SR

(System Reset Required)

F4 Yes

This flag prevents addressable device’s LED from flashing (and

activating the sounder when present). The LED flashes by default

and may only be changed to NO FLASH if the Authority Having

Jurisdiction allows.

Tag 1 Yes

Except for Common Controls, System Status and Man Ena, a 20

character tag can be entered. It will be used to identify the control

in messages, etc. For some Type/Assignment combinations the tag

is generated and cannot be edited.

Tag 2 Conditional

Correlatable Switches (being analogous to Input Zones) accept a

second line of 20 characters.

Account ID Six digit decimal for the SIA report formats and four digit hexadecimal for

Contact ID.

Telephone Text Field for telephone number.

Report Format Choose from SIA110, SIA300, Contact ID

Account ID Six digit decimal for the SIA report formats and four digit hexadecimal for

Contact ID.

Telephone Text Field for telephone number

Report Format Choose from SIA110, SIA300, Contact ID

Dial Using Tone/Pulse

Wait Check to wait for dial tone before dialling

Table 12 Display Adder Info

Name Visible Description