Installation manual

9
Installation
1.0 Installation
You need the following items in order to install the Configurator and connect it to the FX-3500:
• Windows computer with a serial port, USB port, or modem.
• One of the following sets of cables:
• UIMA cable and serial cable.
• USB cable.
• Telephone cable.
• Registered Wibu key.
• FX-3500 Network Configuration Utility (the Configurator).
To connect the Configurator to the Fire Alarm Control Panel you must:
• Install the Configurator.
• Insert the Wibu key.
• Connect the cables.
• Configure Windows.
• Start the Configurator.
Follow the instructions below to complete these steps.
1.1 Installing the FX-3500 Configurator
Follow these instructions to install the Configurator and connect to the FX-3500.
1. Start the Configurator installer:
• If you have Windows 7 or Windows 8, right-click the FX-3500Config icon, and then
click Run as Administrator.
• If you have Windows XP, double-click the FX-3500Config icon.