Specifications

17
Installation
To Surface Mount the Enclosure
1. Using the INX-10A back plate as a template, mark the top of the two mounting hole
locations 11” apart as shown in Figure 1 INX-10A Dimensions.
2. Place the screws halfway into the wall in the position shown using a suitable screw.
3. Hang the box onto the two screws.
4. Screw the other two screws at the bottom of the panel.
5. Tighten all four screws into place.
Figure 2 FA-300TR Dimensions
Figure 3 Flush mounting the enclosure
17"
22.5"
Adhere to surface
around the INX-10A
backbox
Trim Ring Dimensions
TRIM RING
WALL
WOOD OR
METAL STUD
BACKBOX