Specifications

32
Configuration
6.2 DIP Switch Configuration
Configuration is done via a group a five DIP switches located to the left of the LED display
board.
6.2.1 Setting Loop Base Address, Disabling Addressable Loop Interface
Use DIP switch 1 to
• Enable or disable the addressable loop.
• Set the Base Address of the INX-10A.
To configure the desired address, refer to Figure 11 and Table 5.
To disable, configure all switches to 0.
Figure 11 DIP switch address example
Table 4 Setting INX-10A Base Address/ Disabling Addressable Loop Interface
DIP switch 1 Switch
#
Default Setting = 0 Activated Setting = 1 Notes/
Additional
Diagrams
All
(1-8)
Addressable Loop Disabled
Sets the INX-10A base
address. For an addressing
example see Figure 11.
ALL SWITCHES OFF
ALL SWITCHES OFF
1
8
2 3 4 5 6 7
ALL SWITCHES ON
ALL SWITCHES ON
1
8
2 3 4 5 6 7
ON
SW1
SW4
SW3
SW5
SW2
ON
ON
ON
ON
O
N
1
8 234567
1
8 234567
1
8 234567
1
8 234567
1
8 234567
DIP Switches
8763 4 521
0
1
ON
OFF
Address is set to 185