Specifications

38
Configuration
6.3 Single Stage Addressing
Address Assignments are done via DIP switch 2(SW2) which is located to the left of the Main
LED display board. The addresses for the functions are dependant upon the Base Address of
the INX Panel.
There are two types of addressing options
• Basic Reporting
• Enhanced Reporting
In addition, the addressing can be changed by having NACs configured as Power Supplies.
For further information on setting the Base Address of the INX Panel see Figure 11.
6.3.1 Single Stage with Basic Reporting Addressing
To configure the recommended base address
To configure the INX for Single Stage with Basic Reporting in a Mircom system
To configure the INX for Single Stage with Basic Reporting in a Secutron system
Set DIP switch SW1 as: 1-0-1-1-1-0-1-0
ON-OFF-ON-ON-ON-OFF-ON-OFF
Set DIP switch SW2-1 to SW2-4 as: 0-0-1-1
OFF-OFF-ON-ON
Set DIP switch SW2-1 to SW2-4 as: 0-1-1-1
OFF-ON-ON-ON
Table 10 Configuring Single Stage Functions
Function Address Recommended
Address
Common Trouble Base Address 193
Signal Silence Base Address + 1 194
Activate NAC1, return NAC1 line status Base Address + 2 195
Activate NAC2, return NAC2 line status Base Address + 3 196
Activate NAC3, return NAC3 line status Base Address + 4 197
Activate NAC4, return NAC4 line status Base Address + 5 198
Activate NAC5, return NAC5 line status Base Address + 6 199
SW1
1
8 234567
SW2
ON
1 8 234567
SW2
ON
1
8
234567