Owner's manual

CONTROLLER FOR CAMERA, PAN AND TILT, LIGHTS
CABLE (CAMERA ONLY)
Type Minikevlar
Diameter 11.3mm(0.44”)
Maximum length 100m(328ft)
50m(164ft)withhighpowered
lights
Camera Connector ISTC991,24way
Controller connector BurndyMetalokBantam,28way
CONTROLLER FOR CAMERA, PAN AND TILT, LIGHTS
CABLE (FOR PAN, TILT, LIGHTS)
Forothercablelengthswith3x75Wlights,pleasecontactMirion
Technologies.
Note:Pan,Tilt,ZoomwithLightrequiresTV36cable.Minikevlarcan
beusediflightsarenotrequired.
Type TV36
Diameter 16.45mm(.64”)
Maximum length 50metres(164ft)
SPECIFICATION NOTES
1. A“good”pictureisdenedasonewherethe
illuminationavailableissufcientforthecamerato
producea1voltcompositevideosignalwithafully
openiris.
2. A“usable”picturecanusuallybeobtaineddepending
onthesceneviewedandenvironmentalfactors,etc.,
whentheilluminationavailableisonly
1
/
2
thatrequired
toachievea1voltcompositevideosignalwithafully
openiris.
OPTIONS
PanandTiltEquipment-Lighting
50W12voltdcSafelightspotlamp•
50W12voltdcSafelightoodlamp•
75W12voltdcSafelightspotlamp•
75W12voltdcSafelightoodlamp•
CAMERA CONTROLLERS - RC991 CUA PORTABLE
CONTROLLER
Width 400mm(15.75”)(including
carryinghandle)
Height 96mm(3.78”)
Depth 340mm(13.39”)(excludingfeet
andprotectivehood)
Power requirements 90Vto264V,50/60Hz,50VA
maximum(withoutlightingpsu)
CAMERA CONTROLLERS - CONNECTORS
AC power IEC320
Camera BurndyMetalokBantam,28way
Video output 75ohmBNC
Y/C output 4wayminiDIN
CAMERA CONTROLLERS - CONTROLS
Power On/off(rearpanel)
Image Lensmotorspeed,macro,focus,
iris,zoom
Lights Off/intensity
Camera Electronicfocus
Autogaincontrolon/off
Colourtemperature(red/blue)
Colouruniformity(pre-setcontrol)
Indicators Power,Motorlimit,Agcon,
Illuminationlevel
CONTROLLER FOR CAMERA, PAN AND TILT, LIGHTS
Width 438mm(19”)
Height 88mm(3.5”
Depth 359mm(14.1”),excluding
controlsandconnectors
CONTROLLER FOR CAMERA, PAN AND TILT, LIGHTS
POWER REQUIREMENTS - CONNECTORS
AC power IEC320
Camera BurndyMetalokBantan48-way
Video output 75ohmBNC
Y/C output 4-wayMiniDIN
CONTROLLER FOR CAMERA, PAN AND TILT, LIGHTS
POWER REQUIREMENTS - CONTROLS
Power On/off(frontpanel)
Image Lensmotorspeed,macro,focus,
iris,zoompAN
Pan and Tilt Fourcontrols(panright,panleft,
up,down)
Indicators Power,motorlimit,AGCon
illuminationlevel