back to miroil.com Use Instructions for Models - 690HD - 690HS Table of Contents Please choose: Page 1. Title page 2 2. Dear Customer 3 3. Packaging information 4 4. Assembly Instructions 5 5. Filtering Procedure - HD Series 6 6. Filtering Procedure - HS Series 7 7.
Return to main menu Model 690HD Model 690HS (Shown below) (Shown below) Includes Basin Filter Model 905 Includes Pump Out Filter Model 690HD / Model 690HS Do Not Exceed Rated oil Capacity of 45 lbs (6.5 gallons) Division of Oil Process Systems Inc. 602-20 North Tacoma Street PHONE: 610 437-4618 Allentown, Pennsylvania 18103 FAX: 610 437-3377 E-mail: info@miroil.com Web: www.miroil.
Return to main menu Dear Customer: Congratulations on your selection of our Hand Operated Filter Machine which continues over 25 years of leadership in oil management. Your Filter Machine is an important tool for fryer oil management. It is designed to achieve maximum performance for removal of fine crumb and food materials at the lowest cost. ® ® Another important part of oil management is Frypowder oil stabilizer & filter aid.
Return to main menu The following parts are included for assembly Carton #1 for Model 690HD & Model 690HS Assembly of Hot Oil Pump Mounted on Handle Wheel Assembly Discharge Hose Assembly Carton #2 for Model 690HD & Model 690HS Lid and Screws 7.
Return to main menu Assembly of models 690HD / HS Step 1 Step 2. Attach the Wheel Assembly to the Handle and Hot Oil Pump Assembly. Use the Allen wrench and Allen screws in the nutserts in the handle. Insert tube at end of hose (from hot oil pump suction) into the socket on the side of the Filter Basin until the tube is fully seated. Step 3. Step 4. Remove pin, turn & remount crank handle from shipping position to the correct position for pumping. Reinstall pin.
Return to main menu Filter Procedure for Model 690HD for use with fryers with drain valves. CAUTION: Couple the hose. Pull hard on the hose to make sure the lever arms are locked. Make sure hose nozzle is in the nozzle holder tube on the pump. Filter oil at temperatures from 300°F to 350°F Step 1 Step 2 - Swing wheel stabilizers into place as shown in diagram below (figure 1). Place EZ Flow Model 905 Filter in the Basin (see diagram Figure 1).
Return to main menu Filter Procedure for 690HS Series For countertop fryers with lift out fry pans (No drain valves) If you also have fryers with drain valves, buy a D Series Drain Filter for this filter machine Use the Filter Procedure for "D" Series for fryers with drain valves Refer to diagram on bottom of this page: CAUTION: Couple the hose. Pull hard on the hose to make sure the lever arms are locked. Make sure hose nozzle is in the nozzle holder on the pump.
Return to main menu Loss or Damage During Shipment Inspect all cartons for damage before unpacking. Your MirOil pump was thoroughly inspected before leaving our factory. The carrier is responsible for safe delivery. All claims for any loss or damage in transit must be made to the carrier. MirOil will assist with claims IF damage has been promptly reported to the carrier.
