Installation Guide

KITCHEN FAUCET INSTALLATION
Installation
1. Ensure that the water supply below your sink is
completely shut off by turning the shut off valves all
the
way to the right.
3. Insert the faucet into its mounting hole. From
beneath the sink, slide the brass spacer back onto
the
faucet body. Thread the lock nut back onto the
threaded
shank until hand-tight to secure. Finish tightening
using
an adjustable wrench.
Tip: Place a small bucket below your workspace
to
catch any water that may drip during the
installation
process.
2
. Remove the lock nut and brass spacer from the
faucet body. Slide the tapered metal washer onto
the
faucet body followed by the rubber gasket, and
insert
into the base of the facet as shown. The tapered
side of the washer should face up.
4. Attach the sprayer hose to its copper mounting post
as shown. Insert the provided rubber O-ring into the
lock nut before securing. Apply a bit of thread sealant
or plumber’s tape to the threads before tightening.
Important: Hand tighten, then use an adjustable
wrench to give the lock nut no more than a ¼ turn to
complete tightening. Do not overtighten, which can
crack or break the copper mounting post.
Kitchen Faucet Installation Instructions
2