Instructions / Assembly

MOUNTING PLATE
ANCHOR
SCREW
SLOT
ROBE HOOK
SET SCREW
SCREWDRIVER
(not included)
1. Place the MOUNTING PLATE on the wall in the desired location, and mark the center of the top and
bottom MOUNTING PLATE holes with a pencil. Remove the MOUNTING PLATE from the wall.
2. Determine if there is a stud behind the marked hole locations.
2a. If there is a stud behind the marked hole locations, skip to step 5.
2b. If there is NOT a stud behind the marked hole locations, proceed to step 3.
3. Using a 5/16” DRILL BIT, drill holes at the marked hole locations.
the wall.
5. Line up the holes in the MOUNTING PLATE with the hole locations, and attach the MOUNTING
PLATE to the wall with the SCREWS provided.
6. Attach the ROBE HOOK to the MOUNTING PLATE by hooking the SLOT onto the top edge of the
7. Finish attaching by inserting and tightening the SET SCREW as shown.
ASSEMBLY AND INSTALLATION
ASSEMBLY AND INSTALLATION
(CONT.)
1. Place the MOUNTING PLATE on the wall in the desired location, and mark the center of the top and
bottom MOUNTING PLATE holes with a pencil. Remove the MOUNTING PLATE from the wall.
2. Determine if there is a stud behind the marked hole locations.
2a. If there is a stud behind the marked hole locations, skip to step 5.
2b. If there is NOT a stud behind the marked hole locations, proceed to step 3.
3. Using a 5/16” DRILL BIT, drill holes at the marked hole locations.
the wall.
5. Line up the holes in the MOUNTING PLATE with the hole locations, and attach the MOUNTING
PLATE to the wall with the SCREWS provided.
6. Attach the TISSUE HOLDER to the MOUNTING PLATE by hooking the SLOT onto the top edge of
7. Finish attaching by inserting and tightening the SET SCREW-A as shown.
8. Orient the TISSUE HOLDER hook in the desired position, and tighten SET SCREW-B.
ASSEMBLY AND INSTALLATION
ASSEMBLY AND INSTALLATION
(CONT.)
TISSUE HOLDER
MOUNTING PLATE
ANCHOR
SCREW
SLOT
SET SCREW(-B)
SET SCREW(-A)
SCREWDRIVER
(not included)