Installation Sheet

DoorLockInstallation

Step1AdjustLatchBackset

AdjusttheBacksettomatchyourdoor:

A) ToAdjustto2‐3/4”Backsetpullsquarelatchcamout.

B) ToAdjustto2‐3/8”Backsetpushsquarelatchcamin

Step2InstallLatchintothedoor

InstallLatchintodoorpositionedsothatwedgedshapedsideofBoltengages

thestrikefirstwhenclosingthedoor

Step3InstallLockbody

Step4WaveLeverOnlyLeftHandingAdjustment

A) InstallexterioroflockbyInsertingLockSpindleThroughSquareLatchCamand

StudsthroughroundholesuntillockisFlushwiththedoor.

B) ForKnobswithverticalkeyslotstheknobshouldbeinstalledwiththeKeySlot

positionedsothattheKeywillbeteethupwhenused.

C) Installthe

interiorofthelockbyinsertingitoverthespindle.

Insertscrewsthrough

holesandtightendownwithahand‐held

screwdriver.

Note:Checkalignmentofthelockasyoutightenthescrewstokeeplockcenteredover

theboreHole

OnlyShapedLeversneedtobeadjustedforhanding,straightLeverscanbesimply

installedflippedtotheproperhanding..WaveLeversareshippedRight‐Handed.

A) Handlesareremovedbyrotatingthelever45Degreesandpushingtherelease

catchwhilepullingthelockoffthespindle.

B) Onceboth

sidesareofftheycanbeswappedsothatthehandlespointontothe

door.

C) Securetheleversbypushinguntiltheysnapintoplace.Testbypullingoutonthe

lever

Note:Leverscanonlyberemovedwhenthelockisunlocked

Step5InstallStrike

EntryLockonly–

EnsureSecurityPin

SeatsProperly

Right

Wrong

2-3/4”(70mm)

2-3/8”(60mm)