Installation Guide

FIG 5

FIG 4

INSTALLATION PROCEDURE

Insert tank bolts (H) inside the tank. Use rubber washers (F) supplied to create a

seal. (See Figure 3)

Gently place the tank on the bowl with the bolts (H) protruding out underneath. Then

tighten with metal washers (G) and metal nuts (I), tighten enough that the tank sits

flat on the bowl.

Attach the large rubber sealing gasket (J) to the center drain hole under the tank.

(See Figure 3)

Turn the toilet side ways onto a soft surface to avoid scratches on the finish.

Place a new wax ring (not included) around the waste flange of the toilet bowl.

(See Figure 4)

FIG 6

Concealed Toilet With Lever Installation Instructions

Lower the toilet into position so that the bracket are parallel to the inner wall

of the toilet. (See Figure 5) Using a rocking motion, press the bowl down to position the

toilet onto the flange and create a seal with the wax ring.

Insert screw through the mounting hole on the side of the toilet and tighten until it catches

the mounting bracket holes. (See Figure 6)

CAUTION: DO NOT OVERTIGHTEN.

Attach the decorative screwhead covers on each side of the bowl.

FIG 3

• MNO370C