Installation Guide

MODULE INSTALLATION AND USER MANUAL – PERC AND MONO SERIES
REVISION DATE:
06/19/2017
DOCUMENT #
GE- SA1- 0006
PAGE:
6 OF 14
MISSION SOLAR ENERGY - MSE CONTROLLED- PROPRIETARY & CONFIDENTIAL - RELEASED
Reproduction, dissemination, copying, modification, distribution and/or publication of this material is STRICTLY PROHIBITED. Disclosure of this document,
in any manner to a third party, requires prior written consent from MISSION SOLAR ENERGY LLC.
REVISION: R4 RELEASE DATE: 11/16/2016
7.0 UNPACKING AND STORAGE
7.1. UNPACKING
 Use two people when unpacking Mission Solar Energy modules.
 Cut the outer straps.
 Remove the top lid.
 Cut the side of the sleeve to remove it. Always avoid scratching the modules when using cutting
tools.
 Cut the inner straps.
 Remove the modules one at a time. If necessary, use a stand to prevent the modules from
falling while unpacking.
 Lay the remaining modules down on the pallet with the glass side facing upward.
7.2. GENERAL INSTRUCTIONS
 Store modules in a dry place so that modules do not get in contact with moisture.
 D
o not allow children and unauthorized persons near the installation site or storage area of
modules.
 Do not transport modules in an upright position.
 Do not use forklift less 72 inches while handling the module pallet.
 Unpacking module pallet with care and follow the unpacking steps marked on the pallet. Be
careful when unpacking, transporting and storing the modules.
 Do not carry a module by its wires or junction box. Recommended at least two or more people
carry the module for safety concerns.
 Do not place modules on top of each other directly to prevent the modules touching one
another.
 Do not place excessive loads on the module or twist the module frame.
 Do not stand, step, walk and/or jump on the module.
 Do not carry the module above the head.
 Do not drop or place objects on the modules (such as tools.)
 Do not mark the modules with sharp instrument.
 Particular attention should be taken to avoid module back sheet to come in contact with sharp
objects, as scratches may directly affect product safety.
 Do not leave a module unsupported or unsecured.
 Do not change the wiring of bypass diodes.
 Keep all electrical contacts clean and dry.