User`s manual

MS300
30
Maintenance:
1. Wipe down all areas in the sweat path with a damp cloth after each use to prevent rust.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two
reasons:
1) The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the bolts
sufficiently. I cannot stress this point enough; 90% of calls to the service department
for noise issues can be traced to loose hardware.
2) The crank arm nut and/or the pedals need to be retightened.
3. If squeaks or other noises persist, check that the unit is properly leveled. See page 6 for
leveling instructions.
Maintenance Menu in console software:
The console has built in maintenance/diagnostic software. The software will allow you to change
the console settings from English to Metric and turn off the beeping of the speaker when a key is
pressed for example. To enter the Maintenance menu (may be called Engineering mode,
depending on version) press and hold down the Start, Stop and Enter keys. Keep holding the keys
down for about 5 seconds and the message window will display “Engineering mode”. Press the
enter button to access the menu below:
1. Key Test
2. LCD test
3. Functions >
•
••
• Sleep mode – on
•
••
• Pause mode - on (If pause mode is off then console will remained Paused
indefinitely, unless Stop or Start is pressed again).
•
••
• Odometer reset
•
••
• Units – English or Metric
4. Service
•
••
• Motor test
•
••
• Runs resistance motor from level 1~20 and then 20~1.
•
••
• Position sensor value is shown in STEPS data window.
•
••
• Sensor Test
•
••
• SPM window shows reflector sensor #1 signal (1 or 0)
•
••
• CALORIES window shows reflector sensor #2 signal
•
••
• TIME window show Left step position counter
•
••
• STEPS window show Right step position counter
•
••
• PULSE window show speed sensor signal (on or off)