Magellan iCradle Instruction Booklet Retaining Arm Unlock Button Volume Auxiliary Output Status LED Power (USB) Speaker BlueTooth® RESET on back WARNING: Always press the unlock button whenever adjusting the retaining arm.
INSTALLATION Please do not place your iPhone into the cradle until instructed to do so. Assembly. Assemble the cradle as shown. Do not tighten the retaining ring.
Press the unlock button and raise the retaining arm all the way to the top.
Insert your iPhone into the cradle. Slide your iPhone into the connector on the bottom of the cradle and then gently push your iPhone towards the cradle. Press the unlock button and push down on the retaining arm to lock your iPhone in place.
Check for a gap between your iPhone and the cradle. Adjustment Switch If there is a gap, you can slide the adjustment switch on the back to push out the adjustment block so that it rests against the back of your iPhone. (Please note, that if there is still a gap you will need to remove your iPhone. Then pull out the adjustment block, rotate it 180º and place it back in the cradle. This will increase the thickness of the adjustment block, providing for a snug fit.
Mount the cradle in your vehicle. Before mounting the cradle you should remove your iPhone by pressing the unlock button and raising the retaining arm. When mounting the cradle in your vehicle please keep these important guidelines in mind... • Check local vehicle laws regarding mounting devices on windshields. In some areas it is illegal to mount any device on your windshield. • Make sure not to mount the cradle where it could be dislodged should your airbags deploy.
Apply Power Connect the USB end of the power cable to the cradle as shown. Connect the other end of the cable to a vehicle power receptacle.
Reinstall your iPhone into the cradle and adjust for proper viewing. When making viewing adjustments always hold the assembly by the cradle and not your iPhone. Make any final adjustments for proper viewing to the cradle and tighten the cradle retaining ring.
