Installation manual

ADPRO
®
FastTrace™ 2 Series Hardware Installation Manual
21790_05 23
12. If the SATA cables do not have a locking mechanism, use tie-wraps to secure the cables on the
disk(s) in the following way:
13. If there are unused cables left, bundle them with tie-wraps.
14. Fix the front plate (#1701164x or #1701166x) on the base with the screws (#17444080).
Put the cover in place and secure with 10 screws (#17439080).
15. Connect a monitor/screen and keyboard to the FastTrace 2 server. Switch on the power supply and
wait for the boot window to appear.
16. Select XOa Installer and press Enter.
17. The next step depends on the type of hard disk that you are installing:
- If the added hard disk is new, choose Update current system > Manage recording disks and
select the new hard disk in the list. Press Enter. Then choose (using the tab key) Format and use
selected disks. Choose Main Menu and choose Reboot.
- If the added hard disk comes from another server unit, choose Update current system > Mount
all recording disks. Press Enter. Then choose Main Menu and choose Reboot.
The video system now reboots. After rebooting, the new hard disk is ready for use.
3.7 Boot Problems after Adding a HDD with the DH61BE
Motherboard
If you are experiencing boot problems after adding a HDD in a server with a DH61BE motherboard, check if
the SATA cable connections between the HDDs and motherboard are correct. The table below shows the
correct devices and SATA connectors:
Device
SATA Connector
D.O.M.
SATA0
HDD1
SATA1
HDD2
SATA2
HDD3
SATA3
HDD4
SATA6G