Technical Specifications

106
Hangers
© 2015 MiTek. All rights reserved.
JL / JLIF / SUH Face Mount Joist Hangers
Hangers
Option
4
Skewed
1,3
Sloped Seat
2,3
Sloped / Skewed
1,2,3
1) Skewed hangers with skews greater than 15° may have all joist nailing on outside flange.
2) Sloped or sloped / skewed hangers with slopes greater than 15° may have additional joist nails.
3) For skewed hangers, the required cut type (square or bevel) of joist member may vary
based on skew angle and width of hanger. Some square cut hangers will require custom
pricing due to welded back plate.
4) SUH option hangers may be manufactured as welded products to achieve listed loads.
Welded products have a primer finish.
New products or updated product information are designated in
blue font
.
See Sloped Seat and Skewed.
Ex. SUH210_SK45R_SQ_SL30D
See Sloped Seat and Skewed
1˚ to 67-1/2˚
when width is 1-3/4" or less.
1˚ to 50˚ on all others.
100% of table load.
75% of uplift load
on skews greater than 15˚.
80% of table load.
75% of uplift load
on skews greater than 15˚.
Range
Ordering
Allowable
Loads
100% of table load
1˚ to 45˚
Add SK angle required,
right (R) or left (L), and
square cut (
SQ ) or bevel cut ( BV )
to product number.
Ex. SUH210_SK45R_SQ
Add SL, slope required,
and up (U) or down (D),
to product number.
Ex. SUH210_SL30D
Typical SUH26-2
installation
SUH26-2 JLIF
Typical JL26
installation
JL26
Typical JLIF
installation
SUH Specialty Options Chart
Refer to Specialty Options pages 228-229 for additional details.
A
A
D
D
D
W
W
W
H
H
USP offers a wide variety of light-gauge face
mount joist hangers to accommodate application
and installation preferences.
JL series – 20 gauge, 2x joist hangers.
JLIF series – 18 gauge, 2x joist hangers.
SUH series – 16 gauge steel construction
for more demanding applications and light
truss support.
Materials: See chart
Finish: G90 galvanizing; JLIF–G-185 galvanizing
Options: See chart for Corrosion Finish Options.
See SUH Specialty Options Chart.
Codes: See page 11 for Code Reference Chart
Installation:
• Use all specied fasteners.
See Product Notes, page 17.
H