IMPORTANT NOTICE 1 you have any questions rearing wire routing in a vehicles, please contact MTX Technical Support 8th-800-225-5648. When contesting parer and ground wires ensure het the red power wire is fused the paint where it is connected to the cubicle's battery, Femurs fo do 50 een result in damage to the vehicle ita short circuit develops between the vehicle Congestion paint snd the product.
OPERATION 1. Tap the Pews button to turn ths unit on. {Pews, Ground, and ACC wire need to bs connected to a 12¥ power source.) 2 Tap the Prows button to switch modes between Bluetooth and AUX. 3. Hold the Power button for 2 seconds to tum the unit Off. Bets: Tha buttons will stay illuminated 98 long 8s the ACC wits has 12V applied to it 4, The included fuss loop, ring terminals, and butt conservator allow for secy wire connection to a 12V power source.
Tha MUDSLIDE can be suds with any 12-volt battery and can be mounted to & varsity of bars using the included hardware. The unit has three wires in ie wiring pigtail. The red wits, het, should be discreetly connected to the vehicles positive battery terminal, the black wire, ground, should be connected directly to the vehicle's chassis whets paint has been removed or the negative terminal on the battery, and the bis wire, accessory, should be connected to the ignition wire on the vehicle.
MX ‘This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FOC rules. These limits are designed to provide reasonable protection against harmful Interference in a residential Installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radian communications.
