Technical Specifications

ManualsBrandsMiTek ManualsConstruction Hardware3-1/2" x 3-3/8" Skewed Nail Plate

198

Plated Truss

SNP3 Skewed Nail Plate

Typical SNP3 installation

SNP3

The SNP3 Skewed Nail Plate is designed and tested

for connecting square cut corner jack trusses at

skews up to 45˚.

Materials: 16 gauge

Finish: G90 galvanizing

Codes: See page 11 for Code Reference Chart

Installation:

• Install specied fasteners from bend line out from

each end. Not all nail holes will be lled.

• Attach to the supported truss on the acute angle

side so the SNP3 runs behind the end of the jack.

• Set jack truss against supporting truss and nail on

exposed ange.

• Bend angle only once.

• 8d common nails may be substituted for 8d x 1-1/2"

nails with no reduction in load.

Upift Upift

Ref. No. Qty Type Qty Type 100% 115% 125% 160% 100% 115% 125% 160%

SNP3 TJC37 16 6 8d x 1-1/2 6 8d x 1-1/2 530 530 530 530 445 445 445 445

6, R11, F3

1) Allowable loads have been increased 60% for wind or seismic loads; no further increase shall be permitted.

NAILS:

8d x 1-1/2" nails are 0.131" dia. by 1-1/2" long.

New products or updated product information are designated in

blue font

Fastener Schedule

DF/SP

Allowable Loads (Lbs.)

S-P-F

Allowable Loads (Lbs.)

USP

Stock No.

Steel

Gauge

Supporting

Member

Supported

Member

Code

Ref.

Plated Truss

Supporting

truss

3-1/2"

Supported

truss

0°

45°

3-1/2"

3-3/8"

Summary of content (1 pages)

PAGE 1
Plated Truss SNP3 Skewed Nail Plate The SNP3 Skewed Nail Plate is designed and tested for connecting square cut corner jack trusses at skews up to 45˚. Supporting truss Plated Truss Materials: 16 gauge Finish: G90 galvanizing Codes: See page 11 for Code Reference Chart 3-1/2" 3-1/2" Installation: • Install specified fasteners from bend line out from each end. Not all nail holes will be filled. • Attach to the supported truss on the acute angle side so the SNP3 runs behind the end of the jack.