Technical Specifications

174
Truss & Rafter
© 2015 MiTek. All rights reserved.
Typical HTA24-18
installation
Typical TA18
installation
Typical TA16R
installation
TA20R
HTA24-18
HTA24-18
HTA – Offers a higher capacity alternative to the TA model
with two rows of nails.
TA – Anchors are rated for both uplift and lateral loads. They can be
installed straight or eld-bent around truss or rafter members. An
embossed embedment line assures accurate embedment depth.
TAR – Riveted anchors provide a moisture barrier in addition
to uplift and lateral resistance all in one product.
Ma terials: HTA-18 – 18 gauge; HTA – 16 gauge;
TA & TAR – 14 gauge
Finish: G90 galvanizing
Options: See chart for Corrosion Finish Options
Codes: See page 11 for Code Reference Chart
Installation:
• Use all specied fasteners. See Product Notes, page 17.
• Embed 4" into concrete tie beam or masonry bond beam.
• For double anchor installations: anchors should be installed
on opposite sides of wood member and centered in masonry
bond beam.
• Designer may specify alternative nailing schedules. Refer to Nail
Specication table on page 20 for nail shear values, load values
shall not exceed published allowable loads.
• When using alternative nailing schedules, lower-most holes in strap
shall be lled progressing upward towards the top of the strap.
• Straps may be installed straight or wrapped over to achieve
table loads.
• Moisture barrier may be required for HTA installations.
HTA / TA / TAR Embedded Truss Anchors
Continued on next page
Truss & Rafter
F1
F1
F2
F2
Uplift
Uplift
H
F2
Uplift
F1
F3
H
4"
Embedment
4"
Embedment
4"
Embedment
W
W
1-1/2"
1-1/2"
1" Typ.
H
8-1/2"
W
1-1/2"
1"