Technical Specifications

227
General Hardware
© 2015 MiTek. All rights reserved.
NP Nail Plates
TPP – Prong plates with straight prongs.
JNP – Prong plates with angled, hammer-in prongs.
Materials: See chart
Finish: G90 galvanizing
Codes: See page 11 for Code Reference Chart
Installation:
• These products are not intended for
structural use. No load ratings are
assigned. These plates are not intended
for use in truss assembly.
Typical mending plate
installation
Typical nail
plate installation
JNP
TPP
NP
Materials: 20 gauge
Finish: G90 galvanizing
Codes: See page 11 for Code Reference Chart
Installation:
• Use nails appropriate for intended use. Holes are
sized for 8d common or 8d x 1-1⁄2" nails.
• The designer shall determine appropriate load values.
JNP / TPP Mending Plates
Dimensions (in)
Ref. No. W L
NP15 TP15 20 1-13/16 5 12
NP35 TP35 20 3-1/8 5 22
NP37 TP37 20 3-1/8 7 31
NP39 TP39 20 3-1/8 9 40
NP311 TP311 20 3-1/8 11 49
NP45 TP45 20 4-1/8 5 30
NP47 TP47 20 4-1/8 7 42
NP49 TP49 20 4-1/8 9 54
NP411 TP411 20 4-1/8 11 66
NP57 TP57 20 5-3/4 7 59
USP
Stock No.
Steel
Gauge
Number of
Nail Holes
120
Code
Ref.
Ref. No. W L
JNP24 -- -- 18 1-1/2 4
JNP26 -- -- 18 1-1/2 6
JNP46 -- -- 18 3-3/16 6
JNP48 -- -- 18 3-3/16 8
TPP14 MP14 22 13/16 3-1/2
TPP24 MP24 22 1-11/16 3-1/2
TPP36 MP36 22 2-3/4 5-1/4
TPP58 -- -- 22 4-3/16 7-13/16
120
Dimensions (in)
USP
Stock No.
Steel
Gauge
Code
Ref.
General Hardware
W
W
W
L
L
L