Use and Care Manual

322
Copyright © 2020 MiTek Industries, Inc. All Rights Reserved
Specialty Options
Specialty Options
MiTek
®
Product Catalog
Open Top Flange Hanger Specialty Details
See Specialty Options Chart for each hanger series for load
reductions and hanger maximum range of skew, slope, etc.
Skewed Hanger:
• Joist nails may be located on obtuse angle side by MiTek
designer to ensure proper nailing.
• Specify skew angle, type (square cut or bevel cut), and
direction when ordering.
Sloped Seat Hanger:
• Additional nail holes may be added to joist anges by MiTek
designer. All fastener holes must be lled.
• Specify slope angle, direction, and joist height when ordering.
Sloped/Skewed Hanger:
• See nailing notes above for both Skewed Hanger and Sloped
Seat Hanger.
• Specify skew and slope angles as well as skew/slope
directions, and skew type (square cut or bevel cut)
when ordering.
• Similar to face mount skewed/sloped hanger, refer to
illustration on page 321: Typical HD hanger sloped down,
skewed left shown.
• Specify if hanger is to be high side ush, low side ush,
or center ush.
Sloped/Skewed/Sloped Top Flange Hanger:
• See nailing notes for both skewed and sloped hangers.
• Specify skew, slope, and top ange slope angles as well as
skew/slope and top ange slope directions when ordering.
• Hangers may be galvanized or painted.
• Hangers may be made with solid top plate.
Refer to BPH series Special Order Worksheet for ordering
instructions at MiTek-US.com.
Typical BPH hanger
skewed, left shown
(bevel cut)
Typical BPH hanger
sloped seat,
down shown
Typical BPH hanger
skewed right,
sloped down, top ange sloped
Typical HLBH hanger
skewed, left shown
(bevel cut)
Typical HDO hanger
skewed, right shown
(square cut)
Typical BPH hanger
sloped down, skewed right,
high side ush shown
Typical BPH hanger
sloped down top ange
right shown
(this conguration will not
be open back)
Typical HLBH hanger
skewed, left shown
(square cut)
See Specialty Options Chart for each hanger series for load
reductions and hanger maximum range of skew, slope, etc.
Skewed Hanger:
• Joist nails may be located on obtuse angle side by MiTek designer
to ensure proper nailing.
• Specify skew angle, type (square cut or bevel cut), and direction
when ordering.
Sloped Seat Hanger:
• Additional nail holes may be added to joist anges by MiTek designer.
• Specify slope angle, direction, and joist height when ordering.
Solid Top Flange Hanger Specialty Details
Specify angle
Specify angle
Specify angle
Specify angle
Slope
angle
Skew
angle
Specify angle
Joist skew
right shown
Slope
angle
Specify angle
Joist
height
Plumb
height
Specify angle
High side ush
Center ush
Low side ush
90°
90°
Continued on next page