Use and Care Manual

Caps & Bases
105
Copyright © 2020 MiTek Industries, Inc. All Rights Reserved
Caps & Bases
MiTek
®
Product Catalog
Specialty Options:
• KECC – Straps may be rotated 90° on special order
where the W2 dimension is less than or equal to the
W1 dimension. Unless specied W3 and W4 dimensions
are equal to the W1 dimension, and H2 and
H3 dimensions are equal to the H1 dimension.
• KCCO/KECCO – Cap only, no strap design for eld
welding to pipe or other columns.
• KCCOB – For cross beam connections. Any two
buckets can be welded together for a wide variety of
applications. Allowable load shall be the lesser of the
two components.
• KCCT – For T beam intersections, consult MiTek.
Specify beam/column conditions, dimensions, and
loading requirements.
• KCCC – For X beam intersections, consult MiTek.
Specify beam/column conditions, dimensions, and
loading requirements.
• KECCL – For L beam intersections, consult MiTek.
Specify left (L) or right (R) beam/column conditions,
dimensions, and loading requirements.
Dimension call-outs not shown in the table must be
specied at time of ordering for specialty options,
non-catalog, or rough/full size lumber sizes.
Refer to Options for Multiple-Beam Bolted Column
Caps Special Order Worksheet for ordering instructions
at MiTek-US.com on KCC/KECC Column Caps web page.
KCCT
KCCO
KCCC
Optional KECC
rotated straps 90°
KCCOB
KECCLL
left shown
Top View of Specialty Options Column Cap Configurations
KECCLLKECCLL
rotated 90°
KECCLRKECCLR
rotated 90°
KCC
rotated 45° left
KECC
offset left
KCC
offset left
KCC
offset right
KCC
rotated 45° right
KCC / KECC Column Caps
W2
W1
L
4" Typ.
W4
W3
H3
H2
H1
L
H
W1
L
H1
W1
W2
W3
H2
W3
W2
4" Typ.
W1
H2
H1
L
KECC
offset right
L2
W2
H2
H1
L1
W1
W2
L
H
W1