Use and Care Manual

Lumber Hangers
139
Copyright © 2020 MiTek Industries, Inc. All Rights Reserved
Lumber Hangers
MiTek
®
Product Catalog
JL / JLIF / SUH Face Mount Joist Hangers
Option
4
Skewed
1,3
Sloped Seat
2,3
Sloped / Skewed
1,2,3
1) Skewed hangers with skews greater than 15° may have all joist nailing on outside flange.
2) Sloped or sloped / skewed hangers with slopes greater than 15° may have additional joist nails.
3) For skewed hangers, the required cut type (square or bevel) of joist member may vary
based on skew angle and width of hanger. Some square cut hangers will require custom
pricing due to welded back plate.
4) SUH option hangers may be manufactured as welded products to achieve listed loads.
Welded products have a primer finish.
Range
Ordering
Allowable
Loads
100% of table load
1˚ to 45˚
Add
SK angle required,
right
(R) or left (L), and
square cut (
SQ ) or bevel cut ( BV )
to product number.
Ex. SUH210_SK45R_SQ
Add
SL, slope required,
and up
(U) or down (D),
to product number.
Ex. SUH210_SL30D
See Sloped Seat and Skewed.
Ex. SUH210_SK45R_SQ_SL30D
See Sloped Seat and Skewed
1˚ to 67-1/2˚
when width is 1-3/4" or less.
1˚ to 50˚ on all others.
100% of table load.
75% of uplift load
on skews greater than 15˚.
80% of table load.
75% of uplift load
on skews greater than 15˚.
Typical SUH26-2
installation
SUH26-2 JLIF
Typical JL26
installation
JL26
Typical JL210IF-TZ
inverted ange
installation
SUH Specialty Options Chart
Refer to Specialty Options pages 320-321 for additional details.
A
D
W
H
A
D
W
H
MiTek offers a wide variety of light-gauge face
mount joist hangers to accommodate application
and installation preferences.
JL series – 20 gauge, 2x dimensional
joist hangers
JLIF series – 18 gauge, 2x dimensional
joist hangers. For installation at end of post or
beam or where inverted ange is needed
SUH series – 16 gauge steel construction
for more demanding applications and light
truss support
Materials: See chart
Finish: G90 galvanizing; JLIF–G-185 galvanizing
Options: See chart for Corrosion Finish Options.
See SUH Specialty Options Chart
Codes: IBC, FL, LA
Installation:
• Use all specied fasteners.
See Product Notes, page 18.
D
W
H