Use and Care Manual

MiTek

Product Catalog

What's New at MiTek?

MiTek

IHFL (18GA) /IHF (16GA) Face Mount I-Joist Hangers

IHFL/IHF hangers feature speed prongs for temporary placement and seat cleats to grab

the bottom flange of the supported I-joist. Diamond holes in header and joist allow for

optional Max nailing for customized fastening to match allowable load needed, saving

you time and money on the jobsite. See page 206 for details.

MiTek

FWHH Heavy-Duty Fire Wall Hangers

The MiTek FWHH Heavy-Duty Fire Wall Hanger is designed to support beams and purlins

at header locations. The higher capacity of the FWHH is achieved thru top flange bearing

along with added face and beam/purlin nailing. As with the FWH hanger, the advanced

design allows you to install the hangers before the drywall is attached, allowing your

project to be completely framed-up and weather-tight before the drywall sheathing

shows up on site. See page 198 for details.

UGTQ Universal Girder Tiedown

The universal girder tiedown, UGTQ, is a high capacity tiedown designed to resist uplift

loads on multi-ply roof trusses. The UGTQ installs with MiTek's WS structural wood

screws and is fastened on one side for single connector installations or opposite sides for

two connector installations. The UGTQ is available in left and right models for installation

near the end of girders. See page 259 for details.

WSTS Truss Structural Wood Screw

The MiTek

Pro Series

WSTS Structural Truss Screw can be used to resist uplift and

lateral loads for truss/rafter-to-plate and stud-to-plate connections. The WSTS is

tested in accordance with ICC-ES AC233 and AC13 and meets 2018 IRC and IBC code

requirements. See page 260 for details.

MiTek

FWH/S Fire Wall Hangers for CFS Construction

The FWH/S Fire Wall Hanger attaches to cold-formed steel wall framing to support

cold-formed steel joists. See page 337 for details.