Use and Care Manual

312
Copyright © 2018 MiTek Industries, Inc. All Rights Reserved
General Hardware
General Hardware
MiTek
®
Product Catalog
STS
Typical STS1
installation
Stud shoes reinforce joists, plates, studs, or rafters which
have been drilled or notched during construction.
Materials: 16 gauge
Finish: G90 galvanizing
Installation:
• Use all specied fasteners. See Product Notes, page 18.
• STS units are not structurally rated and should not be used
as a total member replacement in structural applications.
• For use with 2" O.D. pipe.
STS Stud Shoes
Dimensions (in)
Ref. No. Description W Qty Type
STS1 SS1.5 18 Single Stud 1-9/16 10 10d x 1-1/2
STS2 SS3 18 Double Stud 3-1/16 12 10d
STS3 SS4.5 18 Triple Stud 4-9/16 14 10d
1) Maximum hole size = 2".
2)
NAILS:
10d x 1-1/2 nails are 0.148" dia. x 1-1/2" long, 10d nails are 0.148" dia. x 3" long.
--
MiTek USP
Stock No.
Steel
Gauge
Fastener Schedule
1,2
Code
Ref.
5"
2-1/2"
2-5/8"
W
KRPS Repair Straps
KRPS repair straps meet IBC, IRC, & L.A. City requirements
for notched plates where placed in partitions.
Materials: See chart
Finish: G90 galvanizing
Options: See chart for Corrosion Finish Options
Codes: See chart for code references
IRC R602.6.1, IBC 2308.5.8
Installation:
• Use all specied fasteners. See Product Notes, page 18.
• Install one strap tie for each 2x plate.
Typical KRPS
installation
KRPS
Ref. No.
WL
Qty Type Tension 160%
KRPS18 RPS18 16 1-1/2 18-5/16
<
5-1/2
12 16d 1345 IBC, FL, LA
12 1345 IBC, FL
16 1790 IBC, FL, LA
12 1345 IBC, FL
16 1790 IBC, FL, LA
1) Allowable loads have been increased 60% for wind or seismic loads; no further increase shall be permitted.
2)
NAILS:
16d nails are 0.162" dia. x 3-1/2" long.
RPS22 16
Fastener
Schedule
2
Dimensions (in)
MiTek USP
Stock No.
3
Steel
Gauge
Code
Ref.
DF/SP
Allowable
Loads (Lbs.)
1
Notch
Width
(in)
Corrosion
Finish
KRPS28 RPS28 16 1-1/2 28-5/16 < 12 16d
1-1/2 22-5/16 <
5-1/2 16d KRPS22
Corrosion Finish
Stainless Steel Gold Coat
HDG Triple Zinc
Corrosion Finish Stainless Steel Gold Coat HDG Triple Zinc
Corrosion
Finish
Stainless Steel
Gold Coat
HDG
Triple Zinc
KRPS18 & KRPS22 5-1/2"
KRPS28 12"
1-1/2"
L