Use and Care Manual

EWP Hangers
209
MiTek
®
Product Catalog
Copyright © 2020 MiTek Industries, Inc. All Rights Reserved
EWP Hangers
HDQIF Inverted Flange Face Mount Hangers
Inverted ange face mount hangers fasten to LVL,
LSL and PSL beams and headers with WS Wood Screws.
Ma terials: See EWP Face Mount Hangers charts,
pages 218-220
Finish: G90 galvanizing
Codes: IBC, FL, LA
Installation:
• Use all specied fasteners. See Product Notes, page 18.
• MiTek’s WS15 (1/4" dia. x 1-1/2" long) and WS3
(1/4" dia. x 3" long) structural wood screws are
supplied with HDQIF hangers.
Designed for medium load conditions. Extended
3" deep seat provides enhanced truss bearing.
Materials: 16 gauge
Finish: G90 galvanizing
Codes: IBC, FL, LA
Installation:
• Use all specied fasteners. See Product Notes,
page 18.
• Joist nails must be driven at a 30° to 45° angle
through the joist into the header to achieve
listed loads. Slant/double shear nails must be
used to achieve listed load values.
HDQIF
Typical HUS
installation
Typical HDQIF
inverted ange installation
Typical HUS double
shear installation
HUS
HUS Face Mount Hangers
Drive joist nails into header
at 30° to 45° to
achieve listed loads.
2"
H
W
3"
Raised dimple
allows 30°
to 45° nailing
3"
H
W
A