Technical Specifications

131
Hangers
© 2015 MiTek. All rights reserved.
Typical WT22
installation
WT22
WT22 Wall Tie
Materials: 22 gauge
Finish: G90 galvanizing
Options: See chart for Corrosion Finish Options
Codes: See page 11 for Code Reference Chart
Installation:
• Use nails appropriate for intended use. See Product
Notes, page 17.
• The opposite end must be bonded in the mortar joint
of brick facade.
• Check local codes for spacing requirements.
• Wall tie shall be bent at nail, bonding into mortar joint.
Ref. No. Description W L Qty Type
WT22 BTB Straight Edge - Duplex 22 7/8 6-1/2 1 10d 120
1)
NAILS:
10d nails are 0.148" dia. x 3" long.
Code
Ref.
USP
Stock No.
Steel
Gauge
Corrosion
Finish
Fastener
Schedule
1
Dimensions (in)
Corrosion Finish
Stainless Steel Gold Coat
HDG Triple Zinc
Corrosion Finish Stainless Steel Gold Coat HDG Triple Zinc
Corrosion
Finish
Stainless Steel
Gold Coat
HDG
Triple Zinc
FHD26 Panel Hangers
FHD26 hanger – Straddles the header and receives
a joist from both sides.
Materials: 18 gauge
Finish: G90 galvanizing
Codes: See page 11 for Code Reference Chart
Installation:
• Use all specied fasteners. See Product Notes, page 17.
• In panelized construction, installers are allowed to nail through
both the sheathing and the hanger top ange with (1) 10d nail.
The nail should be centered in the top ange and be no closer
than 1/4" from the back or front edge of the top ange.
Typical FHD26
installation
FHD26
Uplift
2
Ref. No. W H D Qty Type Qty Type Qty Type 125% 160%
2 x 6 FHD26 PFDS24 18 1-9/16 5-3/8 1-1/2 2 16d 2 16d 2 10d x 1-1/2 960 175 130
1) Loads listed are per side.
2) Uplift loads have been increased 60% for wind or seismic loads; no further increase shall be permitted.
3) Minimum nail embedment shall be 1-5/8" for 16d nails.
4)
NAILS:
10d x 1-1/2" nails are 0.148" dia. x 1-1/2" long, 16d nails are 0.162" dia. x 3-1/2" long.
10d x 1-1/2 nails may be substituted for 16d header nails with a maximum load of 960 lbs.
Code
Ref.
Joist
Size
USP
Stock No.
Steel
Gauge
Joist
Fastener Schedule
3,4
Face
DF/SP
Allowable Loads (Lbs.)
1
Dimensions (in)
Top
Header
3-1/8"
3-3/4"
6-1/2"
7/8"
1" space
between brick
and sheathing
Hangers
H
D
W