User's Manual Part 2
SIP–DECT OM System Manual Release 3.0 9 Configuration und Administration Aspects
9.11.3 Configuring the Start Parameters
The basic data for initializing OMM is stored in the file “/etc/sysconfig//SIP-DECT”. It can be
edited to modify the OMM interface.
##############################################
# OMM configuration file
##############################################
# if you use a different interface for omm activate/correct parameter below
#OMM_IF="eth0"
#
OMM_CONFIG_FILE=/opt/SIP-DECT/tmp/omm_conf.txt
#
#if you use OMM resiliency for OMM activate parameter below with OMMs IP
adresses
#OMM_RESILIENCY="192.168.0.1:192.168.0.2"
#
# Automatic OMM database import:
# TFTP / FTP / HTTP(S) URL specifies the import server and file
#RST_URL=ftp://download-url.com/directory/file.dat
# country tones:
# VS_COUNTRY_DEU = 1, VS_COUNTRY_GBR = 2, VS_COUNTRY_CHE = 3,
VS_COUNTRY_ESP = 4, VS_COUNTRY_FRA = 5, VS_COUNTRY_ITA = 6,
# VS_COUNTRY_RUS = 7, VS_COUNTRY_BEL = 8, VS_COUNTRY_NLD = 9,
VS_COUNTRY_CZE = 10, VS_COUNTRY_AUT = 11, VS_COUNTRY_DNK = 12,
# VS_COUNTRY_SVK = 13, VS_COUNTRY_FIN = 14, VS_COUNTRY_HUN = 15,
VS_COUNTRY_POL = 16, VS_COUNTRY_BLR = 17, VS_COUNTRY_EST = 18,
# VS_COUNTRY_LVA = 19, VS_COUNTRY_LTU = 20, VS_COUNTRY_UKR = 21,
VS_COUNTRY_NOR = 22, VS_COUNTRY_EUN = 23, VS_COUNTRY_SWE = 24,
# VS_COUNTRY_TWN = 25
COUNTRY="2"
Parameters Description
OMM_IF Interface for communicating with the RFPs
(by default: eth0)
OMM_CONFIG_FILE Directory containing the OMM configuration
file (by default: /etc/omm_conf.txt)
OMM_RESILIENCY In case of OMM redundancy, enter the two IP
addresses of the OMMs. See also
section 9.13.
Restore URL Restore URL for an automatic OMM
database import (see chapter 7.4.6.2)
Country tone schema
9.11.4 Specific Commands – Troubleshooting
/etc/init.d/sip-dect [start|stop|restart].
The command line interface for OMM is accessible via telnet on port 8107.
Malfunction
COUNTRY
The OMM software has been installed but does not work automatically when the PC starts.
The command below stops or starts OMM manually (User root):
To check whether OMM is working, see the list of procedures for the “SIP-DECT” process. If
OMM does not start, delete the lock file “/var/lock/subsys/SIP-DECT”.
depl-1230/0.2 Page: 186 (238)